WordPress database error: [Table './meandr_base/anzpz_usermeta' is marked as crashed and last (automatic?) repair failed]
SELECT user_id, meta_key, meta_value FROM anzpz_usermeta WHERE user_id IN (1) ORDER BY umeta_id ASC

0

VHF-FM transmitters-computer speaker system

Many modern Nye applied or game programs during operation should give any sound or voice messages to the user. For restoration of the works of these audio signals using remote Active akus metic system connected to you moves the sound card.

Хочу предложить альтернативный способ, – использование в качестве выносных АС малой мощности обычного FM-радиоприемника или магнитолы с FM-диапазоном, подключаемого к выходу видеокарты при помощи своеобразного «радиошлейфа».

The figure provides a diagram of this device. In fact, it FM transmitter FM radio microphone type, have a look at the source of 5V on the USB connector of the PC, and receives the LF signal with output connections on the same computer.On the transistor VT1 assembled malomoshh s ' frequency generator that you can install the capacitor C4 "in the range 88-108 Mhz. Frequency depends on the contour of the L2 C4. Capacitors C5 and C6 work in a feedback loop necessary to run the generator.

In the same transistor and frequency modulation signal. Voltag tion is created on its base bias resistors R5 and R6. In addition to the base served modulation voltage of SPARE PARTS through the capacitor C3. This leads to mixed amplitude-frequency modulation. But VHF receivers (or FM) very well suppress ampli tudnuju modulation, so the problems with this phenomenon does not occur.

Антенной служит катушка L2. Этого вполне достаточно для приема на УКВ-ЧМ приемник, расположенный не далее метра от неё. Если же дальность нужна больше, то антенну можно подключить к коллек­тору VТ1 через разделительный конденса­тор небольшой емкости. Антенной может быть, например, кусок монтажного прово­да. Но нужно учесть, что емкость антенны будет влиять на настройку контура. И, на­пример, если кто-то близкой пройдет возле неё, частота настройки может отклониться. Узел на транзисторе VТ1 и собран объемным способом в маленьком корпусе (футляр безопасной бритвы) и соединен с системным блоком двумя кабелями, – USB-кабелем и аудиокабелем, с соответствующими разъемами.

Катушка L1 – дроссель на 50-200 мкГн, катушка L2 бескаркасная, – диаметр 15 мм, число витков – 6.

Transmitter tune podstroechnymi capacitors C4 and C5 at the desired frequency and maximum output power. Resistor R3 set nominal level audio signal (without distortion).

Device placed near the receiver or receivers. Operating at a frequency in the range 88-108 Mhz.

Author: Korovin A. E.
Source: Радиоконструктор №8/2017

admin

Leave a Reply

Your email address will not be published. Required fields are marked *